Centurion Gate Lock

Centurion Gate Lock

This lock is a heavy duty device, designed to secure double swing gates. This device is normally installed on the second leaf, and is used in conjunction with a mechanical stop. This secures both leafs against the stop.

This lock requires 24v d.c to retract it and hold it in position when the gates are moving. Once it is de energised, it will extend to the locked position again via a spring return mechanism.

Key Features

• Super heavy duty solenoid bolt electric gate lock.
• Ideal for securing commercial gates at high risk, large leaf gates and wooden gates subject to wind loading.
• 20mm bright steel pin, 60mm long, 50mm travel.
• Optional mechanical over ride keys available.
• For low voltage systems, this lock can be directly powered from 24v batteries. 24v d.c. power supply required for mains powered systems (available below).
• Simple operation, using a relay driven from the gate control panel warning lamp output, the lock is energised for the duration of the gate stroke, and drops down again when power is removed.
• Dimensions 60mm x 60mm x 330mm

Manual Overide Key

• High quality cylinder key
• Provides manual overide
• Required on gates where emergency 24hr access is needed 

Most gate control panels have a permanent voltage output on the flashing beacon terminals when the beacon is active (flashing is handled internally by the beacon). Use this permanent supply signal as a means of switching on power to the lock through a relay during the gate stroke.

Take extreme care when wiring the power supply and relay. Incorrect wiring can damage the power supply and will not be covered by warranty. Please note that optional mechanical over ride keys are available for this lock in the event of power failure