Fermax 9419 10W DUOX plus isolator

Fermax 9419 DUOX plus isolator

The new floor decoder is a device that offers many advantages to make a DUOX PLUS installation more powerful. Quoting the system will be much easier since we depend much less on distances, number of trunks, number of apartments per floor, etc.

Key Features

• Longer derivation distance. 10-outlet floor decoder. One output for each home, allowing a maximum of one terminal (monitor / telephone) per home. Multiple decoders can be installed on each floor. Each outlet allows to increase the diversion distances in floor up to 100 m.
• Isolation between terminals. Isolation from load and signal reflections. If a short circuit or overconsumption is detected in an output, said output is isolated from the rest of the installation (both the DUOX PLUS bus and the rest of the outputs will continue to operate normally).
• Remote programming of the terminals (without entering the home). It is not necessary to enter the dwellings to program the address of the terminals since the decoder includes a group of microswitches (dipswitches) to program the addresses of each of its outputs.
• Lock / Unlock monitor installer menu (only available for V42.18 or higher monitors). After performing remote terminal programming, the decoder locks the Installer Menu on the monitors. In this way, it is no longer possible to access the Installer Menu from the monitor (by pressing F1 + Lock release) preventing the user from modifying installer parameters such as the terminal address. It is possible to Unlock the installer menu: that way from the monitor you can already access this menu. After 30 minutes it locks up again.